Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

what is INSTRUMENTATION ? specify..

Answer Posted / abdul manan

Instrumentation is the branch of science/engineering in
which measuring,monitoring,computing and controling the
process variables,like
temperature,pressure,level,humidity,vibration,flow.also
PH,conductivity,silica,chloride.

Is This Answer Correct ?    9 Yes 3 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

Which is your favourite subject & explain any one topic of it.

7707


this site is owned by an nonsense

1328


Please can anybody help for control valve sizing step by step procedure?

1190


What are the types of valves?

184


Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.

1145






how to calculate the total flow in square root

1250


What is heating effect?

1467


What are different types of orifice plates?

225


How to calibration coriolis flow meter?

855


how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc

1236


Why boiler chimney area  oxyden sensor fixing? 

1656


what is the difference between profibus and controlnet networking.

2116


A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

1297


What is the reason PT speed not incresed in gas turbine?

1432


What is the purpose of bypass valve across AS valve.

1249