Interested to Buy Any Domain ? << Click Here >> for more details...
why middle phase should used for earth fault and other
phases used for over current in overcurrent and earth fault
relay?
- 7 Answers
- 11810 Views
- ABB, ONGC, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
on that point resiudual current is zero normally current sum
is zero at thatt point whenever balance is distrubed current
will flow
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
What is the mmf,rgt and ngt please brief completely
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
Hello to all, Please someone can send me HPCL ELECTRICAL Engg. Sample papers to me? Its urjent....my email address is.... raviasiapacific@gmail.com
What is the difference between rated and per unit in transformer?
what is mind in cable
How to perform a DC resistance test In Alternator and their proceduces?
Can we use shunt trip coil instead of trip coil with protection relay for protection?
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
The height to which the liquid in a tank to be maintained for a certain constant velocity?
What was your role in the silicon evaluation/product ramp? What tools did you use?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
why in the three pin plug all 3 pins are cutted ?
