Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use Y-Y connection in power transformer (8-10 MVA,
132 kV to 11 KV)and D-y in distribution transformer (2 MVA,
11 KV to 440 Volts)?
- 4 Answers
- 11641 Views
- I also Faced
- E-Mail Answers
Answer Posted / mrudang
ok u r using any transformer , anywhere but
the important is what is ur need ?
if u want , in distribution u need 440v -phase to neutral
u r using star connection
u need 11kv hv , u use delta connection
the important is u r using neutral or not generally line
side transformer has delta connected
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
What do you mean by the zone of protection?
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
What is force on parallel conductors ?
why r we using shell transformer for low voltage
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
what is the relationship between phase & neutral
what type of motor used to move a 1 ton gate? and relate ratings with load.
how to get electrical supervisour certificate in gujarat
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
What are the factors influence the choice of an electrc drive?
Electrical 'C' license full abbreviation , and full form
how we can calculate power factor in single phase & three phase ?thank u
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
what is doubling factor in making current of a breaker?
