Interested to Buy Any Domain ? << Click Here >> for more details...
In power point wiring,often,we use less size of earth wire
compared to phase & neutral wire and we use big size pin in
pug top. how is it justified? can we use small size cable
for earthing?
- 3 Answers
- 8846 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / shanmugam annamalai
The reason of earth point in bigger than that others to
save the equipments from leakage current. It means, the
system will be earthed before connecting to the power
supply. Ultimately, if there is any leakage current, it
would bypassed through earth so equipment will be safe.
Please reply, It you need more clarifications
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What is open delta Xformer? It's adavntages & Use?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
Describe Non I.S. Earth System and why is it used?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
what is meant by carrier aided trip protection in transmission line
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
how to decide no of electrodes for 1600A LT Main incomer panel
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
what is circuit breaker in transfomer and where it used
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
why ct ,cvt should be stored in a vertical position?
how to select fuse rating for a 3-phase motor ???
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
what are the 4 rules to start the motor?
