Interested to Buy Any Domain ? << Click Here >> for more details...
A distribution transformer giving afrequency of 200HZ,
where it is rated for 50HZ. when it will occure?
- 2 Answers
- 4799 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjoy_dee0038
when the lamination of core is reduced. Normally it is
0.35mm to 0.50mm. Becauselamination is inversly related to
frequency
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Explain what is clipper and clamper circuits?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What are Contactors? How they works and what its highest rating?
Define peak overshoot.
Is RTCC panel needs any control supply.
what is rocking arrangement in arc heating
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
why we need to us lenz's law for synchornous motor
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
Differentiate between low pass, high pass and band pass filter?
what is mean by dual digital protection in the relay field?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
