Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Frequency while we step up the voltage from
220V to 11KV? Is it possible? Explain it?
- 6 Answers
- 10030 Views
- I also Faced
- E-Mail Answers
Answer Posted / amarnath
it should be or it is 49.5 to 50.5 Hz normally. If this is
not the frequency then we need to have a capacitor to
improve the frequency and power factor.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
What is the meaning of HT Trivector Meter ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is the automatic voltage regulator with servomotor?
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
how to find the multiplication factor for digital energy meter and analog energy meter
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
What is the most important precaution in any experiment with d.c. Shunt motor?
How earthing of switchgear system to be done.
What is the difference between a Root Locus plot and a Bode plot?
What is mean 2XWY
Difference between control junction box (cjb) and power junction box(pjb)?
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
please explain how to do 'pole drop test' on generator?
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
