Interested to Buy Any Domain ? << Click Here >> for more details...
When i went to a interview the interviewer ask me a
question for that i cant able to answer him if anyone knows
answer me
How will you design a capacitor bank for a plant? if my p.f
is 0.6 i have to improve it to 0.9 or 1 what kind of steps i
have to do? and is there any formula for calculating this?
- 6 Answers
- 8544 Views
- APNPDCL, I also Faced
- E-Mail Answers
Answer Posted / saravanakumar
If you want improve your power factor, you should provide a
capacitor bank.The rating of the bank is 1/3 rd of the
transformer ratings.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
What are protections for dty type transformers
If UG power cable both ends are to be earthed or what? If not why?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
what purpose to use excaiter in DG.?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
What happened when voltage will half value of current ...
What is lc oscillator?
How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
What is load boxes ?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
