# 1. Size of slit content in sand.
# 2. Gravity of sand
# 3. Water observation capacity of sand.
# 4. minimum crushing Strength of sand.
Answer Posted / suresh
it is not specified in the relevant code (IS:383) about
silt content, instead it is said that the particles finer than
75 micron.it should not be more than 3% in natural or
uncrushed sand whwre as in crushed sand it is allowed upto 15%.
the gravity of the sand varies from 2.6 to 2.8.generally taken
as 2.65.
water absorption capacity of the sand varies between 0.5 and 1%.
the minimum crushing strength of sand or aggregate should be
80 N/mm^2.
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How can explode a block?
What type of tensile strength is handling by crank in beam? Thanks.
Spider cracks occur in beam bottom due to––
Explain what is the release of lien?
what are the five benefits of using standard terminology in the measurement process?
in the earthquqke the profile of water on dam is parabolic or not
which red: used in roof teping, then use only cement
How to calculate concrete in percentage wise ,for example cement 18% sand 40% aggregate 40% and Stell 2% ,I need and??
What is the use of array command?
how to estimate material requirement for an area of house in square feet?
relation bet Coefficient consolidation Cv, time factor Tv, drainage path d, & time t is Cv=d2Tv/t Cv=d2t/Tv Cv=tTv/d2 Cv=Tv/td2
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
What is rate of concrete surface rendering work per sqm
what is civil all interview questions
20mm thick sand face plaster on walls consisting of 12 mm the backing coat of c.m.(1:3)and 8mm thick finished coat of c.m.(1:1)including scaffolding, watering, finishing etc complete please calculator with methyl et et r u