Why does inductor is connected to dc supply? or what is the
role of an inductor when connected to DC source?
Answer Posted / c_elavarasi@yahoo.com
In DC supply,we wont consider freuency,therefore when
frequency is zero,inductive reactance is also zero.then
what is the purpose of connecting inductor to the DC
source. i dont know the exact answer.
Is This Answer Correct ? | 10 Yes | 8 No |
Post New Answer View All Answers
what happen if drive input fail momentry at 48.5 HZ frequency?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
what is the best transformer oil breakdown voltage?
work of choke in florocent tube circuit ?
Pls mail me utility & Dg related question with answer
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
What are the classifications of heating element?
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
Why is remote backup preferred to local backup?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
what is meant by 3rd hormonics ?
How can we increase fuel-power ratio of any DG set?
why normally Generator rating are between 11Kv to 22Kv?
What are the advantages and disadvantages of closed-loop control system?