Interested to Buy Any Domain ? << Click Here >> for more details...
What voltage is used in Directional earth fault relay? and
why?
- 5 Answers
- 12042 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / ekanadam patlavath
dc 110 voltage used for relay operating. for reverse power
operetion
| Is This Answer Correct ? | 7 Yes | 7 No |
Post New Answer View All Answers
whats the differece between Exd and Exe
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
why we change the direction of winding in rotor ?how we make the north and south pole?
How much weight an electrical engine can pull??
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
Define filter?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
impliment (AB)`+C to transistor representation
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
how to decide no of electrodes for 1600A LT Main incomer panel
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
