Interested to Buy Any Domain ? << Click Here >> for more details...
We operate a 10 Mw facility and we have been experiencing
several trips due to fluctuations on the MVAR? We have
checked all issues related to the AVR and we have found all
OK? Can anyone help us? The grid voltage, internal voltage,
all regular parameters look ok. MVAR fluctuate and there it
goes the unit? What could be happening? Thanks!
- 5 Answers
- 6373 Views
- I also Faced
- E-Mail Answers
Answer Posted / raj
I agree with chaitanya this may happen due to the variation
of reactance produced
by the capacitors connected to that line it will be better
to maintain the Power Factor 0.90 only every where and the
next and only cause is that AVR problem may be some loose
connection in power as well as control side because AVR has
to take care of that MVAR.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how does a liquid starter reduce the starting currents?
Single line diagrams for star to delta and DOL starters.
How will change the frequency in distribution side?
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
STATE USE OF ARC RUNNERS & SPLITTERS ?
What is lighting kitts.
what are carbondioxide and dcp used in fire extinguishers
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
what is parellel power factor correction?
what is apparent poewr, reactive power, & active power?
How to calculate cable size in HT AND LT
I want the details about BHEL company examination.Can anyone able to help me please.
