Interested to Buy Any Domain ? << Click Here >> for more details...
why 4 to 20 ma ,why not 0 to 20 or 3 to 15 or anything
- 19 Answers
- 47306 Views
- Honeywell, TCS, TN, I also Faced
- E-Mail Answers
Answer Posted / aravindan k
beyond 25 mA in live due any damage it cause spark, so the
they maintain below 25 mA it doesnt cause spark even
puncture or damage the live cable......
this is reason for maintain 4-20 mA. so we can use signal
at any environment
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
Draw a great bridge circuit.
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
If we increase only P what will be controller action ?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration
describe flow nozzel principle?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What are de-saturators?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
Conversions
if my flow is 20000 m3/h than which range of DPT i have to use????
full process of gas turbin?
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
