Interested to Buy Any Domain ? << Click Here >> for more details...
According to general circuit diagram of 1-Phase t/f , why
the primary is not get short circuited ,even though the
supply terminals both are directly connected through
primary winding?
- 4 Answers
- 5843 Views
- I also Faced
- E-Mail Answers
Answer Posted / william lobo.
To understand this correctly take the example of a simple
bell in your home. It has only 1 winding and due to this
the solenoid acts and rings the bell. But the number of
turns should be correct or if less then shortciruit may
occur and if more then it will not work the bell.
In general the formula V secondary/ V primary = Turns
secondary / turns primary. i.e. Vs.Tp = Vp.Ts
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how line turns ratio changes in 3 phase with change in connection
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
what is a bus post insulator? explain its application in a substation.
How REF protects transformer alone? explain with diagram.
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Define ohm’s law for a.c (alternating current)?
What is the RME and explain the full form and what is the RME work?
What is the drawback of class b amplifier?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
how works inductive &capacitive sensors?
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
