WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
Answer Posted / kalyan ram
DCS is nothing but connecting more PLC'S in a network and
monitoring it in a control station. The main difference is
in DCS it has in-built SCADA so it is user friendly whereas
in PLC we need to get a SCADA software.
Is This Answer Correct ? | 3 Yes | 12 No |
Post New Answer View All Answers
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
How to Calibrate Ultrasonic flow Transmitter in Field
i want to find out iffco get test paper
What is difference between ESD and PLC please Explain me clearly.
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
What is 1:1 redundancy ?
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
How to Calibrate Temperature Switch in field
How to calibrate smoke Dectector
can you provide me full detail about instrumentation in ONGC??
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
why is an oxygen sensor used in a boiler stack
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?