What is use of 3phase instead of single phase?
- 12 Answers
- 13653 Views
- DCM, L&T, I also Faced
- E-Mail Answers
Answer Posted / adisurendra bandi
using of 3 phase instead of 1 phase,we must get advantages in terms of Economic aspect as well as we get very efficient performance than the single phase,because of we are sharing the load on from single phase to 3 phase.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
How to size fuse? How to size MCB?
what is meant by LCR meter? where its useful ?
whatis the commertial spec. of distribution boards ?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
Readings of ER300P Trivector meter
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
i am venkat i got gre 930(verbal 270 quanta 660) and my toefl score 105..here question is why u got less score in gre ? what i supposed to tell...any chance of rejection is there...my accadamics record is very good
Why do we use copper cable for HT Supply and why not Aluminium?
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
