Interested to Buy Any Domain ? << Click Here >> for more details...
In a 3 phase squirrel cage induction motor why does rotor
rotate?
will 3 phase transformer rotate like a motor if it is
placed on bearings and powered up? give reason
- 10 Answers
- 28629 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / princealekota
In 3 phase squirrel cage induction motor, emf is induced in
rotor circuit. This produces the magnetic field in rotor.
Since we are giving supply to the stator stator magnetinc
field is developed which is revolving and rotor follows the
field. Like rotor speed is following the synchronous speed.
But, in 3phase transformer will not rotate when it is
placed on bearings. Because field developed in the
transformer is not revolving.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is the difference between resistance grounding system and resistance earthing system?
what is capacitor voltage transformer?? how it is different from potential transformer?
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
how much leakage current is allowed in MC61A L&T make relay?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
What will be in Mahagenco Trade Test Exam? I want to know the same.
how is the incoming cable size calculated for a given current rating of a panel??
what is magnetizing and demagnetizing current in generator and motor?
How to select the proper VSD to operate high inertial load
whate is the meaning of balance/unbalance,in stabilizers type
