what is the role of proportional in process control?
Answer Posted / sattar
To maintain one-to-one correspondence between error signal
and manipulated signal.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
Coal mill Instruments Equipments for cement plant And process diagram ?
What is difference between Ionization heat and bimetallic heat
kindly sent some demo question and answer
how to tune siemens sipart electro pneumatic positioner..plz tel me..
What is instrumentation measurement?
What is 1:1 redundancy ?
how to check earthing,what is minum ohms for proper earthing
Why boiler chimney area oxyden sensor fixing?