If we give the 440 V supply at secondary winding of the
transformer then what will affect at primary winding???????
Answer Posted / ashok
no thing will affect. if it is a step down transformer, now
it work as a step up
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
What is negative sequence over voltage element?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
How harmonic block test are conducted on relays ( Siemens,Areva ect )power transformer using omicron kit?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
difference between Ac and Dc mcb ????
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
what happen when increase or decrease size of lamp,light.glass.
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
what is the advantages og idmt relay over magnetic relay??
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating