Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kumar j
Pile foundation is a type of deep foundation which is
used
for structures where the loads are to be transmitted to a
point some distance below ground level.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
which has high compressive strength between hollow block and brick masonry?
What is the withdrawal force of steel nails?
What is a kip?
What is critical path method (c.p.m)?
What are the delays in construction projects due to approvals from owners? How can we analyze them in different prospective? Whats their affects and effects on presently going work?
what is right & short method of measurement of slab&beam
What is proportion of PCC Grade G?
what is pouring and explain
Whats the meanig of ,'K' VALUE in the case of soil.....
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
what is the use of steel rods of 16mm or 20mm used for 4.45mts for closing gutter.one mate consumes how many kgs with a gap of 6inches.
why top layer of block work shoud be full size if any cut block adjustable than another layer?
Design a cantilever slab to carry a live load of 2000 N/m2. The overhang of the slab is 1.20m. b) A slab over a room is 4.75m x 4.75m. The edges of the slab are simply supported and the corners are not held down. The live load an the slab is 300 Kg/m2. The slab has a bearing of 15cm. On the supporting walls. Design the slab as per Rankine - Grashoff theory. Assume weight of R.C.C. = 2400 Kg/m2.
Define unit atmospheric pressure? Difference between gauge pressure, absolute pressure?
how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?
