Generally In transformer Tap Changer on HT side, but I have
seen in 66KV side in 220/66 KV, 100 MVA, Areva make
transformer. Why ?
- 7 Answers
- 9449 Views
- I also Faced
- E-Mail Answers
Answer Posted / intekhab
it is depends on where it is used. if 66kv is in grid side
then it must have to be controlled in 66kv side.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
a governer in an Ic engine controls the
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
i want to model paper for section engg.
How wire size can define in electrical wiring? What is the ratio?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
What is the method of estamating of cable, CB,MCB ?
diff. between tension mode & speed mode
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042
what is efficient motors and how it is different from normal induction motors
How to calculate the Harmonics losses in terms of cost/unit.
I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
Explain the functioning of diode?
when elecromagnatic waves are propogated in a wave guide?
what is saturation kit?which use above 15 kw motors panel side.
