when we start the tube light, then it takes initially 1100
volt, after glow it takes 120 volt?(when we give 220 volt a.c.)
Answer Posted / amarnath
In a Tubelight we have a Choke which is made of Copper or
aluminium coil and when power is supplied this choke acts
as an inductive load and for inductive load initial voltage
required to start is more hence it is so.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Post possible questions for Power Factor Panel FAT / SAT
11 kV line deraction check by an Engineer.
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
how to calculate current and voltage in a same circuit?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
Power Factor Correction Panel (Manual & Automatic)
What is the phase relationship between the primary and secondary voltages of a transformer?
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
What is meant by full pitched winding?
How we select the vector group of 3phase power transformer?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
What is Tachometer used to measure?
Why single phase induction motors are not self starting ?
difference between the applicability of nortons and thevenin theorem