Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
- 55 Answers
- 129062 Views
- ABB, Adani, Adani Power, GMR, IIUC, I also Faced
- E-Mail Answers
Answer Posted / mukesh
plc has more number of instruction as compare to dcs
| Is This Answer Correct ? | 1 Yes | 18 No |
Post New Answer View All Answers
Definition of reverse and acting controllers:
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What is the basic difference between Modbus and CAN Open Protocols
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
what is the different between deflection type measurement and null type measurement in RTD?
how to measure draft pressure in transmitter pl. give its single line digram
What is difference between Ionization heat and bimetallic heat
Emergency Shutdown Systems/ Plant Shutdown System.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
In turbine what does term CDP, NH, HSSOC means.
defination of radial vibration?
