Interested to Buy Any Domain ? << Click Here >> for more details...
My requirement is 1VA,50/5A Current Transformer for
Metering .If I select 15VA , 50/5A CT.Is there any
possibility of Technical Problem ?
- 6 Answers
- 9110 Views
- I also Faced
- E-Mail Answers
Answer Posted / anbuselvan
No problem.
Bcaz CT is an Instrumental Transformer(i,e.,Measurement of
High rating current) to measure only Current.
So there will be no of tapping for each range of current.So
that it will easily sense the rating which u set.
Here both your current rating is same.so no problem at all,
even if the voltage varies.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
distribution is maximum done by a)radial b)network c) parallel d)b & c
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
what do u understand about FACTS? how they are useful?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
What are IR values and what it should be for coil and for insulator
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
what is the mechanical safety of DG ?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
what are the parameters plays a major role in Potential transformer Burden calculation??
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
if a number of plc s are there then how many modbus to be used
What are the basic & Majour problems in UPS ?
number of I/O devices in siemense plc
