Interested to Buy Any Domain ? << Click Here >> for more details...
what is the suitable voltage of transmission line to
transmit 10000w power through 250 km.
(a)11kv
(b)33kv
(c)66kv
(d)132kv
]and please tell me whats the logic behind it
- 7 Answers
- 21220 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / m thiyagarajan
Higher the voltage lower the voltage drop V=IR so 132kv
transmission is better
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
the winding of Generator and Motor is star or in delta ? and why
How to calculate cable size in HT AND LT
how to decide no of electrodes for 1600A LT Main incomer panel
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
PIU how does work?
all interview questions with answers of ntpc (2000-2009
What are the advantages of speed control using thyristor?
errection check list for transformer maintenance
neutral earth resistance testing is it possible for transformer while in load condition
what is the meaning of neutral displacement ???
