Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nisha
smps stands for switched mode ( switching mode) power
supply.This can be used for both ac-dc conversion and dc-dc
conversion...so there is no doubt it can work in dc supply
| Is This Answer Correct ? | 20 Yes | 2 No |
Post New Answer View All Answers
What is difference between safe PLC and normal PLC
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
I'm generating a pulse of 3V with frequency 80Hz (12.5ms time period) and pulse duration 0.125ms and feeding it to a transformer since i want the pulse to get amplified around 60V. At the output amplification s happening but the pulse is changed to a spike, can you tell me what could be the reason? (an ordinary transformer 220V-12V stepdown transformer is reverse connected ie. now it is 12V-220V stepup and voltage amplification happens)
how to discharge 3 phase power factor correction capacitors
kindly send me 11KV MV motor differential protection procedure by primary injection method.
Why is voltage is required to be within permissible range for an electrical equipment?
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
What is the normal phase difference between the voltage and the no-load current in a transformer?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
What is mason's gain formula?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What conditions are required for transformer to operate at low frequencies ?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
