Answer Posted / swayanjit
kw IS THE ACTIVE POWER. IT IS THE POWER THAT CONSUMED BY THE
LOAD BUT KVA IS THE APPARENT POWER.
KVA=(KW/POWER FACTOR)
Is This Answer Correct ? | 21 Yes | 0 No |
Post New Answer View All Answers
How to calculate the value of earth capacitance in a transmission line.
what is the meaning of osr in transformer.
How vfd saving power.
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
Why field rheostat is kept in minimum position?
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
how much cable size required for 70 kilowatt load.
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
What is Anemometer used to measure?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
why do we not use equivalent voltage source in negative sequence equivalent ckt.