For a DY11 lighting Transformer on primary side whee to
connect fourth lead? from nuetral or from ground?
Answer Posted / zeeshan
d means delta connection and in delta there is no nuetral
point
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how net resistance islow in star connection and viseversa in delta connection...? if anybody could explain in detail it wud be helpful.
why the check zone and main zone are used for Busbar Protn. scheem?
what id a dry type transformers and its function ?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What are the commonly used schemes for the bus zone protection?
What is capacitance?
what is the significance of cabability curve of alternator
how to calculate micom relay earth falt time and current sertting
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
how will we calculate the copper wire load..
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
Differenciate between circuit wiring and sub main wiring with illustrations
There are different classes of protections in power plants.class a,b,c are clear..is there any class d and e r there..and elaborate class b protection.