Diploma Mechanical Engineer i had attened more over 100
interviews they are all asking the same question
"TELL ME ABOUT YOURSELF"
- 3 Answers
- 59769 Views
- Automobile, Bajaj, Blue Star, Dr Reddys, Escorts, Honda, Indian Ordnance Factory, Maruti Suzuki, Micro Resources, Neyveli Lignite Corporation, Nissan, Ordnance Factories Board, Polytechnic, Rashmi, Reliance, Steel Plant, TATA, Tata Marcopolo, Tata Motors, Tata Steel Limited, TCS, Toyota, TVS, I also Faced
- E-Mail Answers
Answer Posted / suresh
???? please any one help me in this
Thanking You Suresh
| Is This Answer Correct ? | 65 Yes | 27 No |
Post New Answer View All Answers
How many lubricating holes are there in cylinder?
I have just joined mechanical engineering this year. I just wanted to know the names of the books which would improve my engineering knowledge and skills. Or isthere any other means to improve it?
How do you detect starting valve leaks?
Which case we will find maximum pressure and flow in centrifugal pump - circular casing or volute casing ?
how a cyclone steam separator works?
Is Solid work and solid edge best programs for drawing? what is the difference bewteen them? r there better softwares?
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
Explain how is natural gas better than lpg?
What is the purpose of turning gear
What is the difference between stalling and surging in rotary compressions ?
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
what should be the correct duration of slow firing of the coal based and biomass boiler?
draw p-v dia distingshing naturally aspirated and supercharged engine with reference to pumping loss?
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
what is the trignometry of lifting tools using the wire rope ? any formula for trignometry ?
