Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between potential Transformers and
capacitive voltage transfoemers and where it is used?
- 5 Answers
- 13376 Views
- I also Faced
- E-Mail Answers
Answer Posted / sukhvinder
Potential Transformer is designed for monitoring single-
phase and three-phase power line voltages in power metering
applications.
The primary terminals can be connected either in line-to-
line or in line-to-neutral configuration. Fused transformer
models are designated by a suffix of "F" for one fuse
or "FF" for two fuses.
A capacitor voltage transformer (CVT), or capacitance
coupled voltage transformer (CCVT) is a transformer used in
power systems to step down extra high voltage signals and
provide a low voltage signal, for measurement or to operate
a protective relay.
| Is This Answer Correct ? | 15 Yes | 9 No |
Post New Answer View All Answers
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
How can we findout the maximum efficiancy of Transformer? At which load?
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
what are the factors to be considered while design the breaker either HT or LT??
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
EXPLAIN THE TRANSFORMER MAINTENANCE?
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
What is meant by positive and negative feedback?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
why Lightening Arrester Probe sharp at Top of telecom tower.
star delta starter contorl circuit... drawing..
how are reversing the direction of dc motor
