Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jagan
it is connected bet communication wavedrop and Ct.it is
used for met &pro..it is nothing but acapacitor arrangement
due to this large level of voltage will be stored and due
to small stepdown transfomer inside it is reduced to as
plant req.Ex;400kv/1.732/1.1kv/1.732.
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
how to test reverse power trip?
how flow current in 220 kv line to line
Starting current of a 10 HP induction Motor is ______ time’s full load current.
What descriptive information does the NEC require to be marked on all conductors?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
how many parameters can integrate with fire alarm basically ?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
what is strip power factor?
Pl. brief about break-down maintenance of machine tool.
What is BusBar integrity test and how it is conducted?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
