Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jagan
hi , when u keeps on increasing the voltageby 10% at one
instant ur flux densityincreased by 50% at this point u
say athis as knee point voltage.after u incresing it will
not increase bec this is saturate,,,,,
jagan(Tamilnadu)
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What is relation between transmission lines & Communication lines ?
Iwould like to know barc interview questions
how could we know the size of cable by physical view?
wish of these transformer uses oil?
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
Keywords: Die, Card, Coin, B/N 2 To 12
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
what are the disadvantages in GIS over AIS
why using transformer and thyristor switch in 3 phase apfc panel
which network topology offers the greatest level of tolerance?
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
why does the magnetic balance tests at transformer?
