why overload relay is not tripped at time of starting of
motor allthough staring current is too high?
- 5 Answers
- 9798 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / lokesh
As simple one, we are using the starters ( DOL, Star Delta)
liket that for this purpose.
So this starter will help to start the motor with reduced
starting current.
| Is This Answer Correct ? | 2 Yes | 15 No |
Post New Answer View All Answers
what is the use of piston rings in the engine used for a generator...........
Why synchronous motor is used in power factor improvement,dc series in lift
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
What is meant by derating factor?
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
low frequency protection why recomend?
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
What is nyquist contour?
In parallel operation time both NGR’s close or not close if both close what will happen
what is the practical application of full adder circuit?
What is power factor why we should maintain the power factor unless what will happen
What are the operation carried out in thermal power station?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
what is differentila pilot supervision in the incomer control panel in the power station?
