which software better design in structure design or Rcc
design(STAAD PRO,TEKLA STRUCTURE)
- 43 Answers
- 57578 Views
- I also Faced
- E-Mail Answers
Answer Posted / tushar
anybody...pl.send me the detail about the esteem software &
soft.also,if u have ,pl. send it to my mail
id: tusshar_deo@yahoo.co.in
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
At what point does a circle start losing area when being flattened?
what is anchorage length,lap length and (dont remember the last one)
What you understand by building codes?
how do we design mix ratio?
how to calculate the rebar depth if forgot the foundation reinforcement (main steel)? is that any calculation or formula we have data sheet of supplier what depth what is the pull out capacity is mensioned in data sheet. if any IS code than its help full to me.
Please tell me the quantity of cement, sand, flyash, foaming agent required for 1 cubic meter of cellular lightweight concrete blocks. also , is there any admixtures required for the CLC blocks production.
1. For 10sq.m area(47 kg bitumen contain) of 45 mm thick bitumen mix layer..how much bitumen is required for 1600 sq.m and how much aggregate need for that ?? 2. And much tonnage of bitumen mix required for 10 sq.m area of 45 mm thick. Please give answer...
How does a traffic light signal work ?
it is a corrected question." make a list of engineering property(properties) of soil.
Why steel rods are produced only in even dimensions?
i need the syllabus for the direcr recruitement of executive engineers in andhrapradesh
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
Iwant to calculate the production of 1 labour for concrete casting which includes shuttering,scaffolding,steel fixing,concreting, deshuttering and curing in 8hours.But i am not able to determine it approximately would you pls.??
Minimum and maximum size of the building components
