Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the size of cable for 100 kva load,?can
somebody tell me with a formula
- 7 Answers
- 28155 Views
- Apollo, I also Faced
- E-Mail Answers
Answer Posted / mehul g. c.
if your load is single phase then you should use 3.5c x 185
sq.mm alu. Armoured cable.
| Is This Answer Correct ? | 1 Yes | 12 No |
Post New Answer View All Answers
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
i want to model paper for section engg.
What must be the minimum distance maintained between 2 Generators as per International standards?
how to estimate wiring ins roughing ins. and boxes
what is magnetizing and demagnetizing current in generator and motor?
In how we connect watt meter for open & short circuit test of a single phase transformer.
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
what is p.s impedance measurement test in earthing transformer?
What is the difference between earthing,ground&nutral?
Which contains in POLE ASSEMBLY of a 11KV Kirloskar-make SF6 (Model No-FP620A12)? Will u clarify with drawing?
What is the effect of pi controller on the system performance?
what do u understand about FACTS? how they are useful?
should %impedance be high or low in a power transformer? if so why?
low frequency protection why recomend?
why ct ,cvt should be stored in a vertical position?
