Interested to Buy Any Domain ? << Click Here >> for more details...
how fault in an electric system is detected & hw protection
of equipments is done ?
- 6 Answers
- 9739 Views
- NTPC, RLY, I also Faced
- E-Mail Answers
Answer Posted / riya
Fault is detected by C.B trip or O/L trip.Protection of
equipment is done bu providing earthing, using good
insulation & Using O/L relays.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
why do we have spikes enough to burn electronic boards, when generators are not grounded
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
What is kirchoff ’s current law (kcl)?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
how we can calculate the efficiency of a diesel generator ?
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
what is diff btw electric,magnetic & eletromagnetic field
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
In Power cable specification what is U0/U and Um.
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
How to find out damper winding failure for synchronous machine?
