Interested to Buy Any Domain ? << Click Here >> for more details...
Why Parallel operation of two Transformer are Required?
- 6 Answers
- 14633 Views
- I also Faced
- E-Mail Answers
Answer Posted / reena
Main reason for parrallal operation of trasformer is to work without failure because we need power for 24 hours.
If failure occur or in cse of maitanace we can provide power to the consumer.
Also, one reason is that in parralal operation transformer share the total load.So, instead of one transformer if we have two it save total cost as well as the mainance cost coz we can manage with one if other has fualt so, we can atleat give power to the critical load.
| Is This Answer Correct ? | 7 Yes | 9 No |
Post New Answer View All Answers
What are the advantages of nichols chart?
Define the term factor of inertia.
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
What is meant by impedance? difference between high & low impedance ?
what is earthing.how we make it,describe briefly.
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
What is the basis for framing the rules of block diagram reduction technique?
how to calculate the loss tangent of electrical cables
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
