Answer Posted / syed qamar abbas
Its voltage or you can say a potential difference which
shocks us
| Is This Answer Correct ? | 25 Yes | 5 No |
Post New Answer View All Answers
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
what is physical distance of isolator to VCB in 33/11kv sub stations
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
how much excitation voltage required to generate 1mw power?
we specify current in case of feeder but in case of distributor voltage, why?
why electronic instruments is more favorable than electrical?
how to calculate micom relay earth falt time and current sertting
pre arcing time of ehv breaker
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
Why are lt windings placed near the core?
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
when elecromagnatic waves are propogated in a wave guide?
