Interested to Buy Any Domain ? << Click Here >> for more details...
What is use of 3phase instead of single phase?
- 12 Answers
- 17386 Views
- DCM, L&T, I also Faced
- E-Mail Answers
Answer Posted / vilas
As used 3 phase balanced supply ,we get the advantage to
reduce the size of the motor, no need of capacitor ,
getting improved power factor ,constant torque,saving in
copper for winding ,thus redues the costof the motor,
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
What is the selection process of breakers. Can any one please give a formulation on same?
Make a list observation on Transformer?
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
What are the advantages of speed control using thyristor?
why and how voltage sharing in transformer, during magnetic balance test ?
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
What is block diagram?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
what is cathodic protection and why it use in industries?
