Interested to Buy Any Domain ? << Click Here >> for more details...
why generally transformer are in star to delta or delta to
star used?
- 8 Answers
- 21050 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / sathish n p
Main purpose of using transformer is to convert the power,
Either from high to low or vice versa....i e step up or
Step down....for more deatils go through Power plant or
power system books.. Why transformer is neccessary in
transmission net work..n How the power will converted from
high voltage to low voltage..etc
| Is This Answer Correct ? | 5 Yes | 35 No |
Post New Answer View All Answers
How can we increase the capacity of Energy.?
what is the reqirred voltage in HT motor to get full RPM on no load test?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
How out of step protection relay works?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
what is the circutor?why we use it ?
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
WHat is the general checks required for Dry type transformers
What is meant by reset level of the relay?
Define newton's law of viscosity.
why star point of HT motor not earthed?
why single CT used in DOL starter power circuit?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
how we find transformer capacity by ohm
