Interested to Buy Any Domain ? << Click Here >> for more details...
IN CIVIL ENGINEERING DESIGN WHY WE ARE USING LIMIT STATE
METHOD IS BEST?
I THINK WORKING STRESS METHOD IS BEST?
EX; FOR COLOUMN DESIGN IN LIMIT STATE METHOD AST
IS;1913SQ.MM
SAME TIME WORKING STRESS METHOD IS ;2213.
SO I THINK WORKING STRESS METHOD IS VERY STRONG COMPARE
THEN LIMIT STATE METHOD?
MY OPENING IS CORRECT OR NOT? PLS TO EXPLAIN SIRS
- 12 Answers
- 22478 Views
- I also Faced
- E-Mail Answers
Answer Posted / santhosh kumar
dear
britto/ram/saravanan
pls to sent your mail id to santhoshselvamani@gmail.com
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
sir tell me the formula for calculating the volume of 380mm dia double under reamed pile of 4.0 mts depth.
Calculate the maximum allowable speed on a horizontal curve of radius 350m if the maximum allowable values of the lateral coefficient of friction are 0.14 and the rate of superelevation is 0.08.
how many material required for brickbat water proofing of toilets.
What is the usage of zoom command?
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
what is escalation?how it is done?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
PCC Road Min Grade M 30 for VR standard Mahatashtra load 30 KN. what should be thickness of pavement, width 4m what should be length of panel.
In the different classes or grades of concrete, what is the difference between C20, M20 B20. what are the letters C, M, and B stands for.
If specific gravity of cement is less than 3.15 what is the cause?
what is the composition of good brick ?
How is improve my knowledge in construction industries....
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
Cement consumption of one cubic meter of aerocon blocks masonry?
length where bent up is made in slab of bridge from one end
