What is the Ramping rate of Generator. What mena Ramping
rate
- 2 Answers
- 6970 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / leo felix
Raming tate is the time to reach the rated out put voltage
on no load. on other words the time taken to reach the
rated speed form starting time
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is meant by Low Resistance Cable and High Resistance Cable.
what is submersible pump?what is different between motor and sub motor?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
Define rise time.
what is thresold of perception
how to extend relay operating timing in 24V dc relay card (without using Timer )
sir pls tell me . our ct specifications are 120/5 ,2 core , 0.2 and 5p10 class , 30va and 30va buden. insted of 30 va i want use 15 va. can i use?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
what is reverse power relay brief explanation and in b/w where it is connected
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
what are the analog quality input for protection function?what are minimum reqiments?
