Can we use all 3 cores of a cable to connect DC motor + ve
terminal and similarly one more cable for - ve terminal.
Answer Posted / ashish jani
do not use like 3 core cable due to dc supply only +v & -v
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
operation of protection relay watchdog contact?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
I have finish diploma electronics and five years experience in electrical field in ht service how can i get c licensce or other electrical certificate
Why do not we prefer non conventional sources of energy to conventional sources?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
R=*ΒΆ l/a
How eddy current generation support the idea of train braking?
66kv under ground cable how to layaing in ground any special case two ckt r runing
What are the types of control system?
What is s-domain and its significance?
What is the basic rule for block diagram reduction technique?
How does PLC work for sychronising of Two or more DG sets?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
how much leakage current is allowed in MC61A L&T make relay?