Interested to Buy Any Domain ? << Click Here >> for more details...
why we r used APFC Panel in industrial area.when P.F. low
then wat will be the effect in our system?
- 10 Answers
- 39898 Views
- ABB, Georgio Rocks, Piramal Healthcare, Zenith Engineering Corporation, I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
kva=kw+kvar
apparant power is constant because our TR rating we cannot
alter so if KVAR is incress active power is decress so we
cannot use power for useful for that at the same time for
low PF it draw more currrent so we have to design the
appaliences for higher rating.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what is the control circuit for operating the clean room air shower
when elecromagnatic waves are propogated in a wave guide?
How to connect the chemical earthing and complete process tell me plz
How to measure current and voltage in an ELV circuit
why we need to us lenz's law for synchornous motor
explain different losses in a transformer.
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
When MICC cables used ?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
How many double suspension hardware fittings are required on a double circuit transmission tower?
what is the criteria for selection of conductor used for ehv ac electrical dischrge
Phase control and integral control are used for?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
