DIFFERENCE BETWEEN TRANSFORMER AND CURRENT TRANSFORMER?
Answer Posted / rms
the purpose of transformer is to convert the voltage at a
higher level or lower level depending on what purpose it
will be used. Step up transformers are seen at power plants
and substations so that it can transmit power at very long
distances. Step down transformers are seen attach at
electric post or even in electronic components..
A current transformer and potential transformers are very
important and only seen at thousand volts stations. Since u
cannot directly connect a kilowatt hour meter or other
relaying stuff at thousand volts because it will explode.
You need this ct's and pt's which will adjust the level of
the voltage at a certain ratio where it is now safe to
connect this meters and relaying stuff...
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Why LED light has advantage of rapid reflection ,although other lights alse reflect.? and this light is considered to be best for transmission usage in case of Free optics
difference bewteen reverse current and alternating current
What are the main faults of DC generators?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
Why transformer used in UPS??
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
what is meant by surge? what we called for high currents?
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
explain the types of drives
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
what happened when we supply a dc current in dc motor?? can it worked properly?
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2