Answer Posted / nagori salim

The basic difference betn the two is;

Nominal - Volumetric Batching.

Design - Weight Batching.

In design mix degree of quality & control on quantity is
highly maintained.

With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr

2499

---

Explain what is alternate bid?

1328

---

why we use aggregate,sand with cement in concrete?

10048

---

significance of specific surface area of particles?

2179

---

PL.tell me about civil engineering questions with answer

2597

---

how water proof chemicals act in concrete to avoid leek?

2293

---

Formula for calculating the volume of bulb in underreamed pile

5067

---

length where bent up is made in slab of bridge from one end

1984

---

define the strength

2245

---

What are moment of inertia and its importance in civil engineering?

1364

---

why development length = 50D . why not 100D

2125

---

what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??

3148

---

Minimum concrete cover in slabs, columns, beams, foundation and other st?

1328

---

how do you calculate the quantity of steel,cement for plinth beam. (example size 41'*0.58'*1.08')

2707

---

if dia of slab beam bar is38mm what its clear cover any method of provide clear cover

2102

---