Interested to Buy Any Domain ? << Click Here >> for more details...
WHY TRANSFORMERS ARE RATED IN 11KV 22KV 33KV Instead off
10kv 20kv 30kv
- 4 Answers
- 16620 Views
- BCET, NTPC, I also Faced
- E-Mail Answers
Answer Posted / vipul mali
because form factor is definded by
ff= r.m.s. value/average value
ff= 1/root 2/ 2f/ pi
ff= 1.11
so all the equipments are disigned with this value.
| Is This Answer Correct ? | 20 Yes | 6 No |
Post New Answer View All Answers
hello if any one have papers vof hpcl or sail, plz send me
define the non synchoronism of synchoronous machine in general g or m??
How would your past experience translate into success in this job?
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
what is rocking arrangement in arc heating
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
how line turns ratio changes in 3 phase with change in connection
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
How to calculate the multiplying factor for energy meter with ct ratio given
How can we convert 11 kv to 440 volt without using transformer ?
