Interested to Buy Any Domain ? << Click Here >> for more details...
What is Ohms law?
- 28 Answers
- 35499 Views
- College School Exams Tests, KPTCL, L&T, I also Faced
- E-Mail Answers
Answer Posted / abdul.m
I=V/R
this above ratio clearly shows that current through the
conductor is = to the ratio of voltage to resistance.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is the formula of frequency ?
How to calculate that clean water supply in one Day from 150 KLD STP?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
What is nyquist contour?
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
why output is out of phase in case of common emitter?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
How much no load current of synchronous motor
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
direction of tarbine& genrator
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
a simple c++ program to calculate simple interst with its data members as private
