Interested to Buy Any Domain ? << Click Here >> for more details...
We have a bank capacitor rating of 60 KVAR for a overall
load of 160 KVA and we have connected three loads of 50KVA
each. We would like to auto matically correct PF using APFC.
How do we design it?
- 2 Answers
- 7266 Views
- I also Faced
- E-Mail Answers
Answer Posted / yuvraj gaikwad
devide the 60kvar capacitor into 4 or 6 banks of 15kvar or
10 kvar.use apfc relay of 4/6 stage which wil automatically
switch the cap banks to achive the target power factor.
The apfc i suggest is SYCON apfc which has more features
and available in diffrent models with fifo as well as
intelligent switching.visit website www.syconindia.com
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What are the basic & Majour problems in UPS ?
A parallel flow heat exchanger will perform better than a counter flow heat exchanger. State if the statement is true or false.
What do you understand by external characteristics of a d.c. Generator?
What is the BS(British Standard)code for 11kv motor
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
Determine the BTU size of an aircon for 20 sq metre room
what r the checklist while installing a 380 kva DG set
HOW TO WORK A VFD?SAY SIMPLE METHOD
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
How can we calculate cable size in Low voltage & high voltage
How much load can take a 16 mm aluminum cable 3 phase
how to calculate singlephase motor efficiency?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
