Interested to Buy Any Domain ? << Click Here >> for more details...
1. How many output signals do wew have in process control?
2. Could you write down the names of the pre-commissioning
and commissioning stage test instruments and explain them
(more than 5 items)?
3. What is the first step to commission a transmitter on
service?
4. What is RTD?
5. Find the output value in MA of a temperature transmitter
(RTD Type) at 120degree celius?
6. What is the O/P signal of a pneumatic transmitter?
7. What is the O/P signal of an elctronic transmitter?
8. What is the close loop and open loon?
- 4 Answers
- 10911 Views
- I also Faced
- E-Mail Answers
Answer Posted / tushar
1. Two output signals are used in process control -
analogue and digital.
2. RTD - Resistance Temperature Detector for temperature
measurement upto 600°C.
3. O/P signal for pneumatic transmitter is pneumatic signal
3 - 15 psi
4. O/P signal for electronic transmitter is electrical
signal 4 - 20 mA, 1 - 5 volt.
5. Close loop having sensor, transmitter, controller, and
controlling element (like control valve, on off valve,
damper, servo motor). Open loop does not have controlling
element. open loop is used for only indication in control
system.
| Is This Answer Correct ? | 21 Yes | 0 No |
Post New Answer View All Answers
What is rang ability?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
Explain working principle of lvdt?
what are the steps I have to deal with?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
What is offset in a control system.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
how to calculate control valve bonnet size?? or how to select its material?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
this site is owned by an nonsense
what would be the minimum flow rate that we can measure on rotameter..?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
how the arrangement of equipments done in control room
State bernoulli’s application.
How it the difference between force balance system and dispalacement balance system?
