Why no-load primary current is very small
as compared to full load current in transformer (as 1% of
full load current?
Answer Posted / gunasekaran
no load current is used only for energising the core so it
is 1-2% of full load current
Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
what are the installation procedure of high voltage power transformer,CT,CB&PT?
What is gross error?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
tell me some type of questions throught which i can prepare for exam and do my best
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
how tto ingress mw in turbine explain.procedure ?
how we sesign the transformer give some specifion regarding design of transformers
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
how to deside the capacity of chock for drive?
Which type of DG need Netral Earthing?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
how the works electronic energy meter?
Under wat condition statcom operates as an inductor for the transmission line?
Why can't we parallel Voltage transformer secondary circuits?